Consumer Electronics

View as Grid List

Sort by

Display per page

WAVESHARE 128x64 1.3inch OLED Display HAT for Raspberry Pi

Standard Raspberry Pi connectivity, compatible with and direct-pluggable onto Raspberry Pi 2B/3B/3B+/Zero/Zero W
Optional interfaces: 4-wire SPI, 3-wire SPI, I2C, configured via onboard resistor
1x joystick (5-position), 3x pushbuttons, handy and useful
Comes with development resources and manual (examples for Raspberry Pi/Arduino/STM32)
Driver: SH1106
Interface: 4-wire SPI, 3-wire SPI, I2C
Display color: blue
Resolution: 128x64

$13.69 $15.74

WAVESHARE 128x160 General 1.8inch LCD Display Module with SPI Interface

SPI interface, requires minimum GPIO for controlling
Comes with development resources and manual (examples for Raspberry Pi/Arduino/STM32)
Driver: ST7735S
Resolution: 160x128
Color display: RGB, 65k colors
Operating voltage: 3.3 v
Backlight: LED

$13.24 $16.15

WAVESHARE 1.8inch 160x128 Colorful Display Module for Mmicro:Bit,65K Colors

micro:bit edge connector, directly pluggable
Embedded driver ST7735S, supports 65K colors
Onboard SRAM 23LC1024, used as display cache, no more out of memory
SPI interface, takes up only a few IO pins
Backlight adjustment via PWM
Reserved solder pads for control interface, make it easy to connect with Arduino/Nucleo boards
Driver: ST7735S
Resolution: 160x128

$22.56 $25.94

WAVESHARE 10.1inch Resistive Touch Screen LCD, HDMI interface, Designed for Raspberry Pi

1024 x 600 high resolution,Resistive touch control
Compatible and Direct-connect with any revision of Raspberry Pi (except the Pi 1 model B or Pi Zero, which requires an HDMI cable)
Drivers provided (works with your own Raspbian/Ubuntu directly)
Also works as a computer monitor, in this case, touch panel is unavailable and HDMI cable is required
HDMI interface for displaying, no I/Os required (however, the touch panel still needs I/Os)
Backlight can be turned off to lower power consumption

$79.91 $98.29

WAVESHARE 7inch LCD IPS 1024x600 Display for Raspberry Pi,DPI Interface

1024x600 high resolution
Compatible with Raspberry Pi 2B/3B/Zero/Zero W
The TFT LCD is directly driven by Raspberry Pi DPI interface, refresh rate up to 60Hz
Supports Raspbian, Ubuntu, OSMC, etc.
Backlight can be turned off to lower power consumption
Compact size, suit for various projects
Note: This item can be used for displaying ONLY

$33.59 $41.99

WAVESHARE Mini-Computer Powered by Raspberry Pi CM4 Touch Screen (US Plug)

13.3inch IPS screen,1920x1080 high resolution
6H hardness toughened glass capacitive touch panel, 10-points touch
Mini-computer powered by Raspberry Pi CM4
Powerful controller: Raspberry Pi CM4; Not just a simple display, with powerful Raspberry Pi CM4 (CM4104000) inside
Multiple OS Support: Raspberry Pi OS / Ubuntu / Kali / WIN10 IoT / Retropie
Multi languages OSD menu, for power management, brightness / contrast adjustment, etc.
With USB/ETH port, 3.5mm audio jack, embedded Hi-Fi speaker
Could be a Raspberry Pi tablet: Having fun with this Raspberry Pi tablet, watch movies, listen music

$494.85 $608.67

Waveshare RM500U-CN 5G HAT Quad Antennas LTE-A Multi Band Module Board for Raspberry Pi

Comes with RM500U-CN core module, supports 5G and LTE-A multi network types, supports 5G NSA and SA networking
Integrates extensive network protocols, with multi drivers and software support, compatible with different OS including Windows / Linux / Android
USB 3.1 port (USB 2.0 compatible) for connecting to PC, Raspberry Pi, or Jetson Nano host board to enable high speed 5G communication
Standard M.2 B KEY slot, compatible with different 5G modules: RM500U-CN / RM500Q-CN / RM500Q-GL series
Onboard UART, PWR, and RST control pin, built-in voltage level translator, enabled via DIP switch, for use with hosts like Raspberry Pi or Arduino
Onboard USB-C connector, enabled via switch, for connecting standalone power supply for the module, allows more loads, stable amd flexible power supply
Onboard power supply on/off switch, reset button and LED indicator, easy to turn on/off the module or monitor the operating status
2x SIM card slot, dual card single standby, switchable via AT command

$178.63 $221.50

Waveshare EM06-E LTE Cat-6 HAT Dual Antennas LTE-A Multi Regions Multi Band Module for Raspberry Pi

This is an LTE Cat 6 Raspberry Pi communication HAT with GNSS and up to 300Mbps (downlink) / 50Mbps (uplink) data rate. It is applicable for countries/regions including Europe, the Middle East, Africa, Asia-Pacific, Brazil... By connecting it to PC, Raspberry Pi or Jetson Nano host boards, it is easy to enable LTE-A high speed networking, cloud platform communication, SMS, and global GNSS positioning functions.
Multi-constellation high-accuracy GNSS positioning: GPS, GLONASS, BeiDou/Compass, Galileo, QZSS
Integrates extensive network protocols, with multi drivers and software support, compatible with different OS including Windows / Linux / Android
USB 3.1 port (USB 2.0 compatible) for connecting to PC, Raspberry Pi, or Jetson Nano host board to enable high speed LTE-A communication
Standard M.2 B KEY slot, compatible with different core modules: EM06-E, EM06-J, EM06-A series
Onboard PWR and RST control pin, enabled via DIP switch, for connecting to external IO to turn on/off or reset the module
Onboard USB-C connector, enabled via switch, for connecting standalone power supply for the module, allows more loads, stable amd flexible power supply
Onboard power supply on/off switch, reset button and LED indicator, easy to turn on/off the module or monitor the operating status

$98.33 $119.96

Lily Pi ESP32 Chip WiFi Bluetooth 3.5 Inch Capacitive Touch Screen 5V Relay USB Expansion Port (USB To TTL)

The design and modification are based on the shape and structure of the for Raspberry Pi. The appearance is similar to the structure of the for Raspberry Pi motherboard. The 2 x 20 expansion ports next to it have reserved pins that match the for Raspberry Pi GPIO.
For Raspberry Pi expansion board
TF card holder, self-elastic card holder, easy to pull out the card
Chip: ESP32-WAROVER
Relay: HFD3 5V 2A
RTC: PCF8563
Type-c input: 5V
Purpose: IoT programming development

$57.70 $70.97

WAVESHARE 7 inch 800 x 480 Capacitive Touch Display with Front Camera for Raspberry Pi

Device & System Support
Suitable for Raspberry Pi:
Support Raspberry Pi OS, 5-points touch, driver free
Support Ubuntu, single point touch, driver free
Support Pi 4B
Sensor: OV5647
CMOS size: 1/4 inch
Pixels: 5MP

$72.61 $88.58

WAVESHARE 7 inch 800 x 480 Capacitive Touch Display with Case & Front Camera for Raspberry Pi

Device & System Support
Suitable for Raspberry Pi:
Support Raspberry Pi OS, 5-points touch, driver free
Support Ubuntu, single point touch, driver free
Support Pi 4B
Sensor: OV5647
CMOS size: 1/4 inch
Pixels: 5MP

$79.68 $92.43

WAVESHARE 8 inch 800 x 480 Capacitive Touch Display for Raspberry Pi, DSI Interface

Device & System Support
For Raspberry Pi
Support Raspberry Pi OS, 5-points touch, driver free
Support Ubuntu / Kali / WIN10 IoT, single point touch, driver free
Support Retropie, driver free
Support Pi 4B/3B+/3A+/3B/2B/B+/A+, CM3/3+/4
Note: CM3/3+/4 requires extra adapter board
LCD FFC cable anti-interference design, more stable for industrial application

$62.32 $74.16